Make A Fake ID Do you have plans of creating a fake novelty ID for some good laughs? If so, then you might want to consider reading the entire content of this article in order to make a convincing fake ID regardless if it is a state identification card, driver’s license or whatever. Here are a few steps that you have to be aware of when planning to make one. Step number 1. Scan the ID into the printer or computer – see to it that you have scanned both the back and front sides and note of holographic elements in your ID.
A Brief Rundown of Websites
Step number 2. Open the scan using image editing software – this is basically where the magic happens and by that, I mean the editing of info in the ID.
Sales – My Most Valuable Advice
Step number 3. Insert a new photo – as much as possible, try to get an image that is roughly the same size and resolution as the one present on the valid ID. Zoom in or zoom out of the new photo so by that, the head will be of the same size as what in the original photo. To be able to match with the original photo, you may adjust the brightness and contrast. So long as the new picture is not too dark or too bright, you are doing fine. Step number 4. Change the text fields – try finding fonts that are close to the one that’s used on the current ID, to be safe use courier w/ slab serif especially on older IDs. And for it to be a close match, consider adjusting the font spacing and size. When you are entering a full name, make sure not to abbreviate anything but the only instance when you should use it is for things such as Jr. or III. It’ll be wise move for you to put a realistic birth date as well. When you’re using old ID as your template, you don’t like to keep it that way as it may conflict the year the person was born to how it actually looks personally. Step number 5. Print out the new ID – as you are printing your new ID, put it on a heavy cardstock and make sure that you print both the back and front. Then after, cut out every side of the new ID and glue both sides for them to form a card. All overlapping edges ought to be trimmed. Step number 6. Add holograms – this one is optional but if you wish to add a layer of authenticity to your ID, then adding a hologram will do its job.

Comments are closed.

car & driver